Questions and Answers Available
You are here : Askhoo » Maintenance & Repairs » Currently Reading:

How to Spackle Sheetrock

You may have similar questions as How to Spackle Drywall and How To Spackle,or you may also seek several useful information about How To Remove Ceiling Spackle. In addition,you may be interested in answers related to Instructions on How to Spackle,too. Read more as following:

Spackle is applied to sheet rock using a large putty knife. The spackle compound in thin layers and then sanded. Repeat coats using gradually larger putty knives until you have achieved a smooth finish free of imperfections.


Some information by our algorithm and check these resources as below:

How to Spackle Drywall

To spackle drywall, you would fill any small holes or indentations caused by nail or screws with the spackle. Smooth with a putty knife. Sand it to smooth. Wipe or vacuum off the dust. The joints are done the same way, just on a larger scale. You can… More »

How to Spackle?

You can learn how to spackle with a few simple directions. Start by cleaning the area of any loose material. Use a putty knife to apply the spackle to the damaged part of the wallboard. After it dries completely, you can sand and touch up the paint…. More »

How to remove ceiling spackle?

1. Remove all furniture and accessory items from the room. If this is not possible, make a furniture pile in the center of the room and cover with heavy plastic tarps so that the items will not be damaged. 2. Bring the ladder and work supplies into t… More »

How to spackle a room?

You get some dry wall compound or spackle, and a putty knife/spatula and go around and fill in all holes and cracks and make the walls smooth. Let dry and sand to smooth…. More »

How to make spackling last?

1. A clean putty knife does not leave clumps of dried spackle behind. Open the new container of spackling paste and remove enough of it for your project. Transfer the paste to a clean plastic bucket. Put the top back on the container of spackling pas… More »

How to paint exterior spackle?

1. Clean the hole of all loose debris or flaking paint by scraping it with a putty knife and vacuuming. 2. Scoop out enough spackle with the putty knife to fill the hole. Push the spackle into the hole with broadside of the putty knife until the hole… More »

Nav Links:
If you have something to share or you are an expert on it,share your knowledge with us.

13comments

  1. Mahmoud says:

    One of my bedrooms is upstairs making my home 1 1/2 story. There are lots of “eaves” (I guess that’s the term) and the sheetrock was not evenly cut in the ceilings. It is noticeable and “tacky” looking. I don’t want to replace the sheetrock. How could I cover this?

  2. Eddie says:

    Which is better for patching small holes and gouges in a sheetrock wall?

  3. Ryuuhatake says:

    I am about to put up new baseboards, but I have a few spots where I damaged the sheetrock prying off the old baseboards. I will be using bigger moulding, but it will not cover the damage I did. Any suggestions on how I can patch the areas I messed up?

  4. Kenneth says:

    I am finishing a new room in my basement. Will I notice a huge difference between sheetrock with joint compound vs. a plaster skim coat over blue board? Is it worth the price difference?

  5. Lily Grain says:

    My husband accidentally put a hole in our wall when he was moving the TV. I would say the hole is a little bigger than a golf ball. Do I have to patch the wall? Or can we just use spackle? We were planning on just using spackle but will that crack after some time?

  6. Liz says:

    The person who lived here before me did a HORRIBLE job spackling.

    I can fix this by adding 2 more coats of mud, but the walls are already primered.

    Is it ok to spackle on top of primered sheetrock?

    I am trying to avoid having to sand away many walls full of primer.

    Is it ok to do this?

  7. Lori says:

    Cheap college apartment drywall/sheetrock was damaged. Size of the hole is about 1 foot by 2 feet. What do I need to fix it (cheapest way possible). Thanks.

  8. Jurri Garcia says:

    My husband and I have been stripping wallpaper and some of it had so much glue that it pulled off part of the paper covering the sheetrock. Should we just spackle and sand it or is there a better way to get a smooth surface? Thanks to all who answer!

  9. Lexi ? says:

    im trying to repaint my room and i have a border across the top. which is the easy way without ripping the sheetrock off?

  10. Samuel Johnstone says:

    Some of the paint is chipped off down to the sheetrock.

  11. Loving~mu~amor says:

    I live in a mobile home and I am fixing it up. Our cats have scratched some spots on our walls. The scratches are not deep. There are no holes or anything, just a lot of scratches. The walls are sheetrock paneling. How can I fix/hide the scratches so that I can repaint the walls?

  12. Ayame says:

    These were made when trying to remove a baseboard to replace it. I need to repair quickly I am trying to get it on the market. Thanks!

Share your idea